California Instruments 801RP Series Manual do Utilizador descarregar pdf (Página 127)

MX / RS Series SCPI Programming Manual AMETEK Programmable Power

MX / RS Series 127

TRIG:STATe?

This is a query only command. The response will define the state of the transient trigger

system as follows:

• IDLE The trigger is in the idle state.

• ARM The trigger is waiting for internal syncronization or external trigger

• BUSY The triggered transient is in progress.

• WTRIG The unit is waiting for a trigger event.

On Series II controllers, the trigger state will be updated when the last list point has been

executed. For final voltage or frequency steps with a longer dwell time than needed to reach

the end value, this means the response may change from BUSY to IDLE before the dwell

time has expired. If this affects the application program, it will be necessary to add a final list

point with a short durating (e.g. 0.001 second) to hold the BUSY state till the end of the list.

Note: Firmware revision 0.31 or lower will respond with “ARM” instead of “IDLE” at the end

of transient execution even if the trigger mode is immediate.

Query Syntax TRIGger:STATe?

Returned Parameters <CRD>

Related Commands ABOR TRIG:SOUR

TRIG:PHAS INIT INIT:CONT *TRG

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 222 223

Sem comentários

California Instruments 801RP Series Manual do Utilizador Página 127